Diff'rent Strokers

Hello everyone,
Recently I ordered a set of friction plates from a supplier in my state (South Australia) and when they arrived, there were only 6 friction plates rather than 7. The anti-vibration p ...

Well that sure looks totally ridiculous but also a lot of fun! Very good work! Obviously having a great time with these creations of yours.
Inspiring!

Thanks for the reply.
My RG has been off the ...

Hello everyone,
I am in South Australia and am in need of a set of crank oil seals... 1983 WD Gamma 250.
Can anyone tell me where the best place to go to get them from would be? They do not have to ...

Thanks guys for the feedback. If I can I will see if I can get a photo or two up. The drive shaft is able to be pushed forwards and backwards in the bearing now though, so the bearing I say must be sh ...

Hi again everyone in RG land...
Well Bad news, my bike went bang crunch grind etc, and at one stage the back wheel locked up, so I limped it home to find that the engine housing immediately around ...

Thanks James for the input. I'm afraid I have just got a much more pressing problem now. I will sort the regulator one out after I fix the Engine housing. I am just about to put up a post regarding th ...

Hi everyone,
I recently checked the charging voltage as my battery fluid was getting low to find that at 5ooo rpm the voltage was going to 18.5 volts.
I sourced a second hand unit from a wrecking ya ...

Hi there Pezz,
Have read the thread so far and am wondering where the build is up to?
Any more as yet???
Really keen to see. I like your style!

Thanks for your help with the previous acceleration topic folks, I reckon the bike is going about as well as it should be now. A very easy fix as described. I really appreciate the input.

Now... on ...

Just one clarification, I just went for a decent ride then and I feel that the power is down from around 8000 rpm up... NOT 8500. I was thinking, how does one adjust the timing on these machines? The ...

Well then, another lot of info.
Following you good folk's input, today I once again removed the carbies (which I am sure you all know isn't just a 5 minute job on these things) and had a really good ...

Thanks Straycat,
No I didn't change the main jets. The primary jets were totally clogged and were replaced with the correct same value, but the mains seemed to unblock OK. I did however push a very s ...

Thanks StrokerBoy.
I found out from the previous owner that at the time he stopped riding the bike it was running with way too much two stroke oil (evidenced by the huge amount of oily crap and sludg ...

Hello everyone, I have finally purchased a hobby/toy and after doing all the basics necessary for a machine that has been sitting around for 13 years she runs. There is only 30,000 Km on the clock, on ...